Cutting Unit / Servocutter ASC


With this Ankele machines ASC 20 and ASC 50 we extend our proven machine program within the range non–cutting separation from plastic / rubber profiles, tubes, optical waveguide cables etc.

The servo motor with flanged on cut measurer implements a 360° rotation with adjustable speed, at which the profil is separated. The for the cut execution necessary impulse comes from an rotation transductor which runs along the cutting profil. As cutting measurers can be used different polystyrene blade or special Cutter measurer.

The change–over of clock pulse course on permanent run (rotating) taken place automatically and is lengthen– and speed–dependently. The complete cutting unit can be shifted for better starting of the line approximately 300 mm in extruding direction. The separately standing, mobile switchgear cabinet has plug connection to on the cutter support integrated and for swivelling control cabinet, this makes problem–free integrating of the machine into existing extruding lines. Of course the machine can be implemented also as conditions alone machine.

ASC 20 suitably for smaller hard soft profiles or thin–walled tubing/hoses which a cross section of 25– max.32mm do not exceed.

ASC 50 suitably for middle hard soft profiles or thin–walled tubing/hoses which a cross section of 50mm do not exceed.

Further extras such as conveyor belts etc. or special customized solutions on request.

back